Alarm Lock ETPLN Guia do Utilizador descarregar pdf (Página 14)

14 DL-WINDOWS™ for Trilogy Networx™ V4.0 USER'S GUIDE

Hardware Installation (cont'd)

First Time Gateway Power Up

We supply a "Class 2" 6V power supply (never substi-

tute power supplies; use only the supplied unit) that is

wired to the terminal strip located on the Gateway PC

board. Wiring is non-polarized, so connect either wire to

either of the two terminals.

When the Gateway is first powered, the red light flashes

slowly (about once every 2 seconds), indicating the unit

is looking for a valid IP address (unit may take up to 90

seconds to find a valid address). If the unit finds a valid

IP address prior to 90 seconds, the red light flickers.

If the unit does not obtain a valid IP address after 90

seconds, the flashing rate increases to one flash per

second, and will attempt to find an IP address later.

The one flash per second flash rate indicates the Gate-

way is "configured". At this point you can reset the GW:

Reset the Gateway

At this point, the Gateway is mounted and connected to

the router (or the network) with the RJ-45 cable. Apply

power to the Gateway and the red light flashes slowly,

about once every 2 seconds. Before securing the Gate-

way housing cover, reset the Gateway memory--even if

the Gateway has never been used. Press and hold the

"RESET" button and the red light turns on continuously;

continue to hold the button and the red light will start to

flicker. Release the button and the red light will continue

to flicker.

"Resetting" the Gateway clears all memory and ensures

that any residual voltage or test data existing from the

factory is cleared from the unit. Always reset the Gate-

way for new installations; you can also reset the Gate-

way anytime after the Gateway is powered. Secure the

Gateway housing cover with the screws provided.

Note: See page 25 for additional information regarding

resetting the Gateway.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 67 68

Sem comentários

Alarm Lock ETPLN Guia do Utilizador Página 14