
23
; 6 4 :
64. Disable Remote Input
• Wire a Normally Open Contact to Wires (White & White). Momentarily close switch to unlock door
to allow person to pass through door.
• Enter the functions below to Disable/Enable the Remote Input.
NOTE: The Remote Input is enabled as part of the default program.
Remote Input
; 6 5 :
65. Enable Remote Input
2
REMOTE INPUT
62-63. Reserved
60. Number of Attempts Before Lockout
61. Set the Attempts Lockout Time
Used with Function 61
• Number of attempts before lockout must be 1-9 attempts.
• The number of attempts is reduced by half every time the keypad is locked out without a
successful code entry (default is 6 attempts).
• The attempt count is reset each time a valid code is entered.
Function 61 determines the length of time the keypad is locked-out after a series of
unsuccessful attempts (default is 15 seconds). Used with Function 60.
• Lockout Time must be 1-60 seconds.
4
4
LOCKOUT
; 6 6 ; [ _ _ ] :
(Ambush Code)
66. Ambush Code
• Ambush code must be 2 digits.
• An error will sound if the Ambush Code matches the 1st two digits of any User Code.
See Function 67 for more information about the Ambush Function.
• Factory default Ambush Code is 99.
3
AMBUSH
; 6 0 ; [ _ ] :
(Number of Attempts)
; 6 1 ; [ _ _ ] :
(Lockout Time)
59. AL-DTM Door Number
*With the introduction of DL-Windows v3.5.1 and the AL-DTM-III (and future versions of these
products), Function 59 is no longer used. The description below is for use with older versions of
DL-Windows (and AL-DTM versions 1 and 2) and is included here for reference only.
Using the AL-DTM-II, up to 96 locks can be Downloaded/Uploaded and History Logs can be
retrieved. Enter a door number for each lock. After configuring the AL-DTM-II, using Alarm
Lock's DL-WINDOWS Software, any of the following data transfers can be initiated by plugging
the AL-DTM-II into the lock and simply entering the User Code for User 299 at the lock.
• Upload Lock Program
• Upload History Log
• Download Lock Program
4
AL-DTM2
; 5 9 ; [ _ _ ] :
(Door Number)
Programming Functions (cont'd)
Comentários a estes Manuais