Alarm Lock NETWORXPANEL Especificações Página 1

1 GENERAL DESCRIPTION The NETDK and NETPDK (with proximity card reader) are secured single-door or double-door digital keypads for use within t

10 BASIC WIRING EXAMPLES EGND AC IN WOA WO W1 PWR GND RED LED WIEGAND INPUT GRN LED SNDR DRIVE (+) (–) TX (YEL) RX (GRN) N/O N/C COM AUX RELA

11 NOTES

12 NETWORX CONTROL PANEL WIRING DIAGRAM AC IN, 16.5V/60HZ VIA TRF14 CLASS 2 TRANSFORMER DO NOT CONNECT TO SWITCHED OUTLET. GREEN ACTIVITY LED LD1 E

2 Operating Temperature: 14-120°F (–10-49°C) Input Power: 16.5VAC via Class 2 Plug-In 50VA Transformer (supplied model TRF-14)

3 gand "Data 1" wires to this terminal. (T7) PWR: If one Wiegand device is used, connect the "+ DC" power wire to this terminal.

4 steel-reinforced concrete or metal lath and plaster can reduce NETWORXPANEL transmitter strength as much as 90%. Note: In difficult installa

5 INSTALLATION STEPS All inputs and outputs, electric door strikes, card readers and all other accessories should first be installed as de-taile

6 will beep if the door was left open after a User passes; all keypads (or sounder-equipped Wiegand devices) will beep in the event of a door "ki

7 Relay is available to be used for a variety of purposes. With the Main Relay dedicated to operating the door locking device, the Aux Relay is avail

8 the 10-minute "startup timer", you must remove power from the keypad(s) and re-apply power (disconnect wires from the power source and re-

9 hold : with the series of beeps heard (and re-lease the button), and no further buttons are pressed, a short chirp will sound to indicate your 15 s