Alarm Lock Eagle 6000 Manual do Utilizador descarregar pdf (Página 14)

ES2400 – ES2403 – ES4800 - ES6000

User's Manual

___________________________________________________________________________________________________________________________________________________

When the jumper is set to position NORMAL, the MRG controller works normally.

When the jumper is set to position TEST, the MRG controller performs the complete charge

cycle in seconds, instead of minutes.

When a battery is connected:

• if the voltage is lower than the gassing value, the EagleSmart will go in Emergency

Stop after 20-30 seconds.

• If the voltage is higher than the gassing value, the EagleSmart will terminate the

charge and pass to the automatic equalize in a few seconds.

- End of manual -

__________________________________________________________________________________________________________________________________________________

Page 14/14

ATTENTION!

It's always necessary to keep the battery disconnected

while moving the QuickTest jumper.

ATTENTION!

After performing a quick test cycle, make sure to move the jumper to

position NORMAL before to put the charger in service.

If the QuickTest jumper remains in position TEST, each charge

cycle will terminate within 20-30 seconds, therefore the battery will

not be charged!

1 2 ... 9 10 11 12 13 14 15 16 17 18

Sem comentários

Alarm Lock Eagle 6000 Manual do Utilizador Página 14